Insta360 X4 Screen Protector | original tempered glass for the Insta360 X4 camera screen

Screen Protector

Clear display, extra protection.

Fits like a glove.

Designed specifically for the X4 to perfectly fit every inch of the screen. No place left uncovered.

Additional camera protection.

High-strength tempered glass, resistant to impacts and scratches. Don't worry about anything.

Pay no attention.

With over 90% light transmission, you'll get the same clarity and brightness as your X4. It's as if he wasn't there at all.

Easy to install.

Comes with a full set of accessories for easy installation at home. No bubbles, no hassles.

Installation

1. Clean the screen with a screen cleaning wipe and a screen cloth. Use a dust removal sticker to ensure your screen is free from dirt.
2. Align the alignment tool with the camera screen.
3. Remove the film from the screen protector. Place the screen protector on the screen using the alignment tool, aligning the end of the "Insta360" screen protector with the "Insta360" end of the camera screen. Slowly move the screen towards the shield until it is covered, then remove the alignment tool. Avoid pressing on the center of the screen protector as this may trap air bubbles underneath.
4. Scrape the screen protector from the end of the lens towards the end of the "Insta360" until all air bubbles are removed.

Notes

• When removing air bubbles, scrape them from the lens side of the screen protector towards the end of the "Insta360" to prevent air bubbles from forming.
• Do not reinstall the same screen protector. Dust that has collected on the screen protector can cause air bubbles to form and reduce adhesion.
• If the screen protector moves during installation, use a film removal stick to remove the screen protector and repeat the above steps. Do not completely remove the installed screen protector.